HomeMy WebLinkAboutFile Documents.311 Park Ave.0319.2017 (36).ARBK Residential Design Standardslb
Administrative Compliance Review Staff Checklist - Single Family and Duplex THE CITY OF ASPEN
Address:311 Park Ave, Aspen, CO.
Parcel ID:273718100049
Zone District/PD:R-6/PD Approved: Digitally signed by Garrett
Garrett imer
Ryan
Lee DN:cn=Garrett Larimer
Representative: plans/elevations attached) Larimer Date:2017.10.25 15:10:00
Email:rlee@forumphi.com (Approved 0600
Phone:405-314-5104
Disclaimer: This application is only valid for the attached design.If any element of the design subject to Residential Design Standards changes prior to or during building permit review, the
applicant shall be required to apply for a new Administrative Compliance Review.
illl
Standard C ies Alternative Does Not Sheet#(s)/Notes
Compliance Comply
B.1.Articulation of Buildin Mass The property is outside the Aspen Infill Area `
(Non-flexible) g RECEIVEr
�lt, �
[ I
B.2.Building Orientation v I Not in scope 12/2 9/2 017
(Flexible) I v ASPEN
BUILDING DEPARTMENT
B.3.Build-to Requirement ri Not in scope
(Flexible)
The one story element on this property is a loggia that does not meet the current standard for loggia as a one
B.4.One Story Element 1 story element but the proposed scope of work does not include alterations in the depth of the deck.The
(Flexible) proposed scope of work includes a reduction in the width of the front story element,but would still meet the
minimum square footage and width requirements per section 26.410.030.4.2 of the Land Use Code.See Z-201
C.1.Garage Access i No access from private street or alley. Not in scope.
(Non-flexible)
C.2.Garage Placement r No change in location proposed.
(Non-flexible)
r 1The proposed garage door is less than 8' in width and the overall width of the front
C.3.Garage Dimensions façade is over 40'. Since the proposed garage door meets the garage door to front
(Flexible) facade ratio minimum, this standard complies. See Z-210
Page 1 of 2
Garrett p'sS_ m;
Approved•Larimer g afar, Residential Design Standards11
Administrative Compliance Review Staff Checklist rHEcnY OF ASPEN
Disclaimer:This application is only valid for the attached design.If any element of the design subject to Residential Design Standards changes prior to or during building permit review, the
applicant shall be required to apply for a new Administrative Compliance Review.
C.4.Garage Door Design I I I The structure has only one garage door, there is no need to utilize an
(Flexible) articulation technique to break up the façade. See Z-201
The applicant proposes a change to the front entry door. The alteration would move the front
D.1.Entry Connection entry feature closer to the street and align the feature with the widest front facing façade of
(Non-flexible) the building.The entry door is unobstructed as seen from the street. See Z-201, Z-102
D.2.Door Height 1 The front door is shown at 7' 5-1/4" with a 1'5-3/4" transom above. See
(Flexible) Z-201
RECE1V _ ,
D.3.Entry Porch 1 The height of the loggia on the front façade of the building is1spm§lt2017
(Flexible) one story. See Z-201
ASPEN
r The proposed remodel shows at least one principle windovnit6 RTMENT
E.1.Principle Window p p p p
(Flexible) more that four feet by four feet. See Z-201
E.2.Window Placement All fenestration on the front facade of the building is shown spanning
(Flexible) r less that one story. See Z-201
E.3.Nonorthogonal Window Limit No non-orthogonal windows are shown on the front façade of the
(Flexible) building. See Z-201
E.4.Lightwell/Stairwell Location The light-well is not located on the front most façade of the building.
(Flexible) See Z-102
Materials are presented consistently on all sides of the building. Materials are also shown in ways
E.5.Materials that are true to their characteristics,stone veneer is used as at the base of the exterior walls,with
(Flexible) ile existing horizontal wood siding above the stone veneer. See Z-201,Z-202,Z-203,Z-204
Page 2 of 2