HomeMy WebLinkAboutFile Documents.1112 Waters Ave.0089.2017 (5).ARBK Residential Design Standardsili
Administrative Compliance Review Staff Checklist THE CITY OF ASPEN
Address: 1112 Waters Ave., Aspen, CO. 81611
Parcel ID:273718266012
Digitally signed by Hillary
Zone District/PD:R-15 Approved: Hillary Seminick
Tim Andrulaitis DN:cn=Hillary Seminick
Representative: plans/elevations attached) Seminick Date:2017.05.03 10:31:14
tim zone4architects.com (Approved osoo
Email:tim@zone4architects.com
970.429.8470
Disclaimer: This application is only valid for the attached design.If any element of the design subject to Residential Design Standards changes prior to or during building permit review, the
applicant shall be required to apply for a new Administrative Compliance Review.
'mil.
Standard Complies Alternative Does Not N/A Sheet#(s)/Notes
Compliance Com 1
B.1.Articulation of Building Mass Dimension from Front Most Wall @ Entry Level to Rear Wall is no greater
(Non-flexible) than fifty (50) feet in depth.
r 1Waters Avenue changes its orientation at the approximate location of 1112
B.2.Building Orientation Waters.The proposed design orients towards both front yard street aspects,
(Flexible) with the entry door and front-most facade facing the street as it approaches
from the North,and the Southern portion of the residence facing the circle.
B.3.Build-to Requirementr _r_
Lot is curvilinear
(Flexible)
1
B.4.One Story Elementr 1 The overall building width is 58' -1 3/8". The oggia is 11' - 7 1/2" and
(Flexible) meet the 20% RDS requirement. Please see sheets Z105 and Z201.
C.1.Garage Access ce The property has no alley access.
(Non-flexible)
r Front-most element of the garage is set back at least ten (10)feet further
C.2.Garage Placement from the street than the front-most wall of any street-facing façade of the
(Non flexible) principle building. Please see sheet Z!05.
The width of living area on the first floor of street-facing facade on which the
C.3.Garage Dimensions garage is located is at least five(5)feet greater than the width of the garage.
(Flexible) r 1 rThe total width of vehicular entrance that is visible from the street does not
exceed twenty-four(24)feet.Please see sheet Z105.
Received
Page 1 of 2
5/15/17
Hillary s�m:n-
o Residential Design Standards
Approvedaemmick�:3�"B,,.o,.o,
11
Administrative Compliance Review Staff Checklist THEcnY OF ASPEN
Disclaimer:This application is only valid for the attached design.If any element of the design subject to Residential Design Standards changes prior to or during building permit review, the
applicant shall be required to apply for a new Administrative Compliance Review.
opiowN-..
C.4.Garage Door Design I I I Two-car garage door will be constructed as two separate doors. Please
(Flexible) see sheet Z105 and Z201.
Entry door faces the street and is not set back more than ten(10)feet from
D.1.Entry Connection 1 the front-most wall of the front facade of the principal building.Fencing,
(Non-flexible) hedgerows,walls or other permitted structures will not obstruct visibility to
the door.Please see sheet Z105.
D.2.Door Height II All doors facing street are not taller than eight (8) feet. Please see sheet
(Flexible) Z105, Z201, Z202, Z203 and Z204.
D.3.Entry Porch le Entry porch on the front façade of the principal building is not more than
(Flexible) one story. Please see sheet Z201.
E.1.Principle Window Font facade has at least one (1)group of windows that when measured as a
(Flexible) r group has dimensions greater than four(4)feet by four(4)feet. Please see sheet
Z201.
E.2.Window Placementr Street facing windows does not vertically span more than one story.
(Flexible) Please see sheet Z201.
E.3.Nonorthogonal Window Limit Building has zero (0) non-orthagonal windows on any façade. Please
(Flexible) see sheets Z201, Z202, Z203 and Z204.
E.4.Lightwell/Stairwell Location No lightwells, areaways, skylights or stairwells are located between the frontmost
(Flexible) wall of street facing façade. Please see sheet Z105.
E.5.Materials The quality of the exterior materials and their application is consistent on all
(Flexible) sides of building. Materials are used in ways that are true to their
characteristics. Please see sheets Z201, Z202, Z203 and Z204.
Received
Page 2 of 2
5/15/17