HomeMy WebLinkAboutFile Documents.302 E Hopkins Ave.0108.2018 (4).ACBK Date SDS Prepared: May 31,2015 Page 1 of 5
�•! dalifie®
IMAGINE WHAT'S POSSIBLE"'
SAFETY DATA SHEET
NATURAL STONE PRODUCTS
Product Series: Granite Collection
G771-Absolute Black
1. PRODUCT IDENTIFICATION
Common Name: Natural Stone Products (For purposes of this SDS,the term"Natural Stone"encompasses all types of
Stone products sourced by Dal-Tile Corporation.)
Synonyms: Natural Stone Products and Wares
Manufacturer Name: Dal-Tile Corporation
Address: Headquarters Office
7834 C.F.Hawn Freeway,Dallas,TX 75217
Emergency Assistance: Environmental,Health and Safety Department
Richard Ray-(214)309-4295
1-800-933-TILE;(214)398-1411 (24-hour number)
Recommended Use: Building Material-Natural Stone products sourced by Dal-Tile Corporation are natural building
materials typically used as floor/wall and countertop coverings. Should you desire additional
information,please direct your inquiry to the address above.
This document has been prepared in accordance with the Occupational Safety and Health Administration(OSHA)Hazard Communication
standard,29 Code of Federal Regulations(CFR)1910.1200(g),Safety Data Sheets.
2. HAZARDS IDENTIFICATION
Natural Stone products are mixtures of Quartz,Feldspar,and other natural occurring minerals that have been mined. The finished,Natural
Stone products are odorless,stable,non-flammable,and pose no immediate hazard to health. Respiratory,hand and eye protection may be
needed to prevent excess exposure to airborne particulates if dust is produced by cutting product during installation or if dust is produced by
any other operations,including demolition/removal projects.
Emergency Overview: Danger!Lung injury and Cancer Hazard
GHS Classification(Global Harmonized Standard Classification):
Carcinogenicity Category 1A(H350)
Specific target organ toxicity,single exposure;Respiratory tract irritation-Category 3(H335)
Specific target organ toxicity,repeated exposure-Category 1A(H372)
GHS Label,Hazards and Precautionary Statements
GHS Pictogram:
Crystalline Silica: Category 3(Respiratory tract irritation)(H335)
Categories 1A(Carcinogenicity)(H372)
Label Signal Word: Danger
Hazard Statements:
(H350) May cause CANCER(inhalation)
(H335) May cause respiratory irritation
(H372) Causes damage to organs(lung/respiratory)through prolonged or repeated exposure(inhalation)
Date SDS Prepared: May 31,2015 Page 2 of 5
2. HAZARDS IDENTIFICATION(CONT)
Precautionary Statements:
Do not handle until all safety precautions have been read and understood.(P202)
Do not breathe dust/spray.(P260+P261)
Wash skin thoroughly after handling.(P264)
Do not eat,drink or smoke when using this product.(P270)
Wear protective gloves,protective clothing,eye protection,face protection.(P280)
Potential Health Effects:
Inhalation:Do not breathe dust. See"Health Hazards"in Section 11 for more details.
3. COMPOSITION/INFORMATION ON INGREDIENTS
Natural Stone products are composed of Quartz,Feldspar and other naturally-occurring minerals,that have been mined.
Natural Stone Products are mined and fabricated into various shapes,sizes,and colors.
These products do not contain asbestos.
Under normal conditions these products do not release hazardous materials after installation and are not considered hazardous waste should
disposal be necessary.
CAS#/
Composition EINECS# Estimated%by Wt. EU Class
Limestone CAS: 1317-65-3 0-100 (67/548/EEC)
EINECS:207-439-9 Xi R36/37/38
Crystalline silica as quartz CAS: 14808-60-7 0-72 (67/548/EEC)
EINECS:238-878-4 Xn R48/20
Feldspar CAS:68476-25-5 0-15 (67/548/EEC)
EINECS:270-666-7 Non Haz.(by Directive)
Biotite CAS: 12001-26-2 0-5 (67/548/EEC)
EINECS:215-479-3 Xi R36/37/38
Iron Oxide CAS: 1345-25-1 0-2 (67/548/EEC)
EINECS:215-721-8 Xi R36/37/38
4. FIRST AID MEASURES
Eyes: Immediately flush eyes with large amounts of water for at least 15 minutes if dust gets in
eyes. Get medical attention if irritation persists.
Skin: Wash thoroughly after working with Natural Stone products.
Inhalation:
Remove to fresh air if exposed to large amounts of dust. Administer artificial respiration
if breathing has stopped. Keep victim at rest. Call for prompt medical attention.
Ingestion: Not applicable for intact natural stone products.
Have emergency eyewash station available in area where products are cut.
5. FIRE-FIGHTING MEASURES AND INFORMATION
Flash Point(Method Used): Not applicable
Autoignition Temperature: Not applicable
Flammable Limits(%by Volume in Air): LEL-not applicable
UEL-not applicable
Fire Extinguishing Media: None required Non-flammable
Special Fire Fighting Procedures: None required
Fire and Explosion Hazards: None
Date SDS Prepared: May 31,2015 Page 3 of 5
6. ACCIDENTAL RELEASE MEASURES
Avoid creating excessive dust. Clean up dust with a vacuum system with a High-efficiency particulate(HEPA)air filter vacuum or damp
sweeping.See Section 8 of this SDS concerning PPE information for clean-up.
7. HANDLING AND STORAGE
When cutting,grinding or removing,use equipment with integral dust collection and/or use local exhaust ventilation. Use wet cutting
methods to reduce generation of dust. Use respiratory protection in the absence of effective engineering controls.
Do not store near acids. If natural stone products contact some acids,damage/discoloration to the surface may occur.
Shelf life is unlimited.
8. EXPOSURE CONTROLS/PERSONAL PROTECTION
8.1 Exposure Table
OSHA NIOSH ACGIH
Composition Units
PEL IDLH TLV*
Crystalline silica as quartz 10 0.05 0.025 mg/m3
-respirable fraction %SiO2+2
-total dust 30 N.E. N.E. mg/m3
%SiO2+2
Limestone
-respirable fraction 5 5 5 mg/m3
-total dust** 15 10 10 mg/m3
Feldspar
-respirable fraction N.E N.E. N.E. mg/m3
-total dust** 15 N.E. N.E. mg/m3
Biotite
-respirable fraction** 5 15 3 mg/m3
-total dust** 15 N.E. N.E. mg/m3
Iron Oxide
-respirable fraction 10 5 5 mg/m3
*2006 Edition,respirable fraction to be determined as per Appendix D of ACGIH TLV.
**Covered as particles not otherwise regulated per OSHA and particles not otherwise classified per ACGIH.
N.E.-Not established
8.2 EXPOSURE CONTROLS/PERSONAL PROTECTION
Ventilation: Use adequate ventilation to keep exposure to dust below recommended exposure levels. Avoid inhalation of dust. The
highest probability of silica exposure occurs during installation using dry cutting methods or during removal of installed natural stone
tile. Wet cutting methods are recommended.
Respiratory Protection: Use of a properly fitted NIOSH/MSHA approved particulate respirator is recommended when cutting natural
stone products for installation or during the removal of installed product.
Eye Protection: Use dust-proof goggles or safety glasses with side shields. Contact lenses may absorb irritants. Do not wear contact
lenses in work areas.
Skin Protection: Cotton or leather work gloves should be worn when cutting this product to minimize skin exposure to dust and/or cuts.
Wash hands prior to eating,drinking,or smoking,and at the end of the work shift,after cutting operations are conducted.
NOTE:Personal protection information in Section 8 is based on general information for normal uses and conditions. Where
special or unusual uses or conditions exist,it is suggested that the assistance of an industrial hygienist or other qualified
professional be obtained.
Date SDS Prepared: May 31,2015 Page 4 of 5
9. PHYSICAL AND CHEMICAL PROPERTIES
Appearance: Brittle solid;color may vary
Odor: Odorless
Melting Point: Not Available(>1000°F)
Boiling Point: Not applicable
Vapor Pressure: Not applicable
Vapor Density(Air=1): Not applicable
Solubility in Water: Insoluble
Specific Gravity(H2)=1): 1.6 to 2.6
Percent Volatile by Volume: Not applicable
Evaporation Rate(Ethyl Ether=1): Not applicable
Viscosity: Not applicable
10. STABILITY AND REACTIVITY
Stability: Stable in current form.
Conditions to Avoid: Avoid contact with acids(e.g.,Hydrochloric,acetic,hydrofluoric,etc.)
Incompatibility(Materials to Avoid): Avoid contact with acids(e.g.,Hydrochloric,acetic,hydrofluoric,etc.)
Hazardous Polymerization: Will not occur.
Hazardous Decomposition Products: None.
11. TOXICOLOGICAL INFORMATION
Potential Health Effects
Primary Routes of Exposure
None for intact natural stone products. Inhalation and potential exposure to eyes,hands,or other body parts if contact is made with broken
tile,and/or during procedures involving the cutting of products,and/or for operations involving the removal of installed products.
Acute Effects
No acute effects from exposure to intact natural stone products are known. Working with broken or cut natural stone produces a potential for
cuts to the hands and exposed body parts. Acute effects such as eye irritation may occur if associated with high dust operations such as dry
cutting or during the removal of installed product. hi very rare cases,symptoms of acute silicosis,a form of silicosis(a nodular pulmonary
fibrosis)associated with exposure to respirable crystalline silica,may develop following acute exposure to extremely dusty environments
caused by generation of tile dust. Signs such as labored breathing and early fatigue may indicate silicosis;however,these same symptoms can
arise from many other causes.
Chronic Effects
No chronic effects are known for exposure to intact natural stone products. Long-term,continual exposure to respirable crystalline silica at or
above established permissible occupational exposure limits may lead to the development of silicosis,a nodular pulmonary fibrosis(NPF).
NPFs are also associated with pulmonary tuberculosis,bronchitis,emphysema,and other airway diseases. This type of chronic exposure to
silica dust may also result in the development of autoimmune disorders,chronic renal disease,and other adverse health effects.
Recent epidemiologic studies demonstrate that workers exposed to elevated silica concentrations have a significant risk of developing chronic
silicosis. Signs such as labored breathing and early fatigue may indicate silicosis;however,these same symptoms can also arise from many
other causes.
Potential Adverse Interactions
Silicosis may be complicated by severe mycobacterial or fungal infections and result in tuberculosis(TB). Epidemiologic studies have
established that silicosis is a risk factor for developing TB. Any existing respiratory or pulmonary diseases may be complicated by exposure
to respirable crystalline silica. Smoking may increase the risk of adverse effects if done in conjunction with occupational exposure to silica
dust at or above permissible exposure limits.
Carcinogen Status
Respirable crystalline silica is classified by the International Agency for Research on Cancer(IRAC)as a Group I Carcinogen(carcinogenic to
humans). The National Toxicology Program(9th Report)lists respirable crystalline silica as"Known to be a Human Carcinogen".
USDOL/OSHA and NIOSH have recommended that crystalline silica be considered a potential occupational carcinogen.
Overview of Animal Testing
Short term experimental studies of rats have found that intratracheal instillation of quartz particles leads to the formation of discrete silicotic
nodules in rats,mice and hamsters.
Date SDS Prepared: May 31,2015 Page 5 of 5
11. TOXICOLOGICAL INFORMATION(CONT.)
Oral(silica)Lethality
LD50 Rat oral>22,500 mg/kg
LD50 Mouse oral>15,000 mg/kg
LC50 Carp>10,000 mg/1(per 72 hr.)
12. ECOLOGICAL INFORMATION
No information available at this time.
13. DISPOSAL CONSIDERATIONS
Waste should be disposed of in a landfill certified to accept such materials in accordance with federal,state,and local regulations.
14. TRANSPORTATION INFORMATION
D.O.T Shipping Name: Not applicable
Hazard Class: Non-regulated(for disposal purposes material is non-hazardous Class III regulated material)
ID Number: Not applicable
Marking: Not applicable
Label: None
Placard: None
Hazardous Substance/RQ: Not applicable
Shipping Description: Natural Stone/Granite products
Packaging References: None
15. REGULATORY INFORMATION
This product and/or its components have been previously introduced into U.S.commerce and is listed in the Toxic Substances Control Act
(TSCA)Inventory of Chemicals in Commerce. Hence,it is subject to all applicable provisions and restrictions under TSCA 40 CFR Section
721 and 723.250.
This natural stone tile contains<1 percent by weight each of the following elements,which are SARA 313 Recordable:Antimony,Arsenic,
Barium,Beryllium,Cadmium,Cobalt,Chromium,Copper,Manganese,Mercury,Nickel,Lead,Silver,Thallium,Tin,Titanium,Vanadium,
and Zinc.
Title 22 Division 2,California Code of Regulation Chapter 3(Proposition 65): This product contains a chemical or chemicals known to the
State of California to cause cancer and/or birth defects or other reproductive harm.
This product or its components meets the following hazard definition(s)as defined by the Occupational Safety and Health Hazard
Communication Standard(29 CFR Section 1910.1200):
Combustible Liquid _Flammable Aerosol Oxidizer
Compressed Gas _Explosive Pyrophoric
Flammable Gas X Health Hazard(Sections 3&11) Unstable
Flammable Liquid _Organic Peroxide Water Reactive
Flammable Solid
Based on information presently available,this product does not meet any of the hazard definitions of 29 CFR Section 1910.1200.
Note: The information in this data sheet provides information related to the potential hazards associated with dusts which may be produced
during cutting or otherwise changing the shape of the product during installation and/or removal.
16. ADDITIONAL INFORMATION
Global Harmonization Identification System
GHIS: Health:3 Fire:4 Reactivity:4
Hazardous Material Identification System
HMIS: Health:0 Fire:0 Reactivity:0
National Fire Protection Association
NFPA: Health:0 Fire:0 Reactivity:0