HomeMy WebLinkAboutFile Documents.617 W Bleeker St.0062-2019-BRES (2)0062-2019-BRES_Zoning_2
Page: Z0-08 HEIGHT OVER TOPOGRAPHY
Checkmark: Unchecked
Author: jimp
File Name: 200409_ARCH_1803_PERMIT SET_200408.pdf
I am not seeing pitches called out for any
of these low angle roofs. Without a pitch,
we would assume that it is less than 3:12.
If so, then the height measurement point
needs to be the highest point on any roof
plane.
200409_ARCH_1803_PERMIT SET_200408.pdf (2)
Page: Z0-09 HEIGHT OVER TOPOGRAPHY
Checkmark: Unchecked
Author: jimp
File Name: 200409_ARCH_1803_PERMIT SET_200408.pdf
This dormer/cupola is sitting on the low
angle roof leading down to the side of the
house. Per the language in
26.575.020.F.2.g, to be an exempt
dormer, it cannot be taller then the roof it
is sitting on. This is clearly taller, and
therefore must meet height restrictions. I
do not see a detail showing the pitch, but
it appears to be less than 3:12. If so, then
we will need a height point at the highest
spot on the cupola, if more than 3:12,
than we will need a point halfway up the
roof line. Regardless, #12 and #15 do not
appear to be the correct height points.
7921.59
SURVEY POINT
7922.02
SURVEY POINT
7922.17
SURVEY POINT
7922.37
SURVEY POINT
7922.23
SURVEY POINT
7922.35
SURVEY POINT
7922.63
SURVEY POINT
7921.64
SURVEY POINT
7922.62
SURVEY POINT 7923.27
SURVEY POINT
7923.32
SURVEY POINT
7922.97
SURVEY POINT
7922.84
SURVEY POINT
7922.80
SURVEY POINT
7922.93
SURVEY POINT
7922.64
SURVEY POINT
7922.41
SURVEY POINT
7922.79
SURVEY POINT 7923.58
SURVEY POINT
7923.60
SURVEY POINT
7922.95
SURVEY POINT
7921.98
SURVEY POINT
7921.65
SURVEY POINT 7922.17
SURVEY POINT
PR
O
P
E
R
T
Y
L
I
N
E
LINE OF SETBACK
LIN
E
O
F
S
E
T
B
A
C
K
6
5
3
1
2
4
8 7
11
9
10
14
12
13
15
16
I am not seeing pitches called out for
any of these low angle roofs. Without a
pitch, we would assume that it is less
than 3:12. If so, then the height
measurement point needs to be the
highest point on any roof plane.
7
7
8
1
9
10
4
6
12
14
15
16
XONOMETRIC
= 1'-0"1 3D AXONOMETRIC
SCALE: 1/8" = 1'-0"
This dormer/cupola is sitting on the low angle roof
leading down to the side of the house. Per the
language in 26.575.020.F.2.g, to be an exempt
dormer, it cannot be taller then the roof it is sitting
on. This is clearly taller, and therefore must meetheight restrictions. I do not see a detail showing
the pitch, but it appears to be less than 3:12. If so,
then we will need a height point at the highest spoton the cupola, if more than 3:12, than we will need
a point halfway up the roof line. Regardless, #12
and #15 do not appear to be the correct heightpoints.